“Antheor” IOR Half Ton – 1985
Race ready condition.
Sail number SWE-9155
Photos on Facebook: Antheor – Halfton Sailing
Winner Halfton Cup, Porto Ercole, IT, 1985. Skipper Pierre Mas, France.
9,05 x 3,11, 2.400kg.
Built by Collignon Shipyard, Montpellier, France, for owner Philippe Frantz. Kevlar, Carbon and Epoxy. Forward area empty. Saloon with two bunks, stove, nav. and sink. Bunks under cockpit aft. Lead keel in combination with internal lead ballast. The IOR concave under the stern, has been filled out by previous owner when measured in IMS. New Jefa rudder 2016.
Mast: Aluminium profile Z 290, converted with trough bar spreader fittings. Rod rigging, Diamonds and Runners. Spinnaker halyards at top and partial.
Boom: Aluminium, Swede Spar.
Boom strut with internal spiral spring and outer cascade kicking strap.
Spinnaker boom: Carbon, Ceilidh 4m. One spare boom in aluminium and same length.
Main, North 3dl 600 – 2014
Genua, North 3di 760M – 2015
Jib, medium/heavy with reef, North 3dl 600– 2015
2 x Spinnaker “large” masthead, North, old but workable.
Spinnaker North S5, 175, partial for reaching and heavy weather - 2015
Some older sails for transport or cruising.
Keel, lead, original Andrieu design. Epoxy treated, final layers with Cu-powder.
Rudder, Jefa, Racing series rud31R – 2016. Epoxy treated, final layers with Cu-powder.
Nexus log and dept. Various old Nexus instruments in a carton at the side.
Tiller-Autopilot, Raymarine St 1000, Very little used and only when motoring in calm.
Volvo Penta MD 6A, 10 Hp, Original
Maxprop, Fethering, probably original, in very good condition.
All necessary sheets and lines.
Compasses, 2 x Plastimo bulkhead mounted.
Anchor with chain and line.
Two burner alcohol stove, Origo 2000.
Sink with Whale foot pumps.
Water tank, soft bag, Plastimo.
Stainless tiller arm.
Winches, selftailing Barbarossa/Harken.
Fittings, blocks and tracks, mainly Harken.
2 x Batteries. Start 70 amp and consumption100 amp.
Antifouling, International/Interlux VC 17 m on hull. Keel and rudder epoxy with cu. powder.
Flag pole with Swedish flag.
|Builder:||Daniel Andrieu - Shipyard Collignon, France|
|Model:||IOR Half Ton|
|No. of engines:||1|
|Engine model:||Volvo Penta|
|Drive type:||Shaft drive|
|Length over all:||9.5m|
|Hull material:||Carbon Fibre|
|Keel type:||Fin Keel|
|Fuel capacity:||15 Litres|
|Water capacity:||20 Gallons|